Diving System for Revell (05114, 05133) type: IXC, IXC40 1/72

 


Battle of the atlantic


 Chart Diving units JOG-4

 


 KIT JOG-4

ACUMULATOR PACK
This case is made for recharchable batteries. It's extendable and has a guiding clamps which allows easy connection to the RC compartment.

DIVING CONTROL SYSTEM WITH BALLAST TANK

A diving control system is connected to the ballast tank and pressurized air tank. The airtank has a reduction vent which leads into the ballast tank. The vent has in-built lever operated by servo motor, which also operates the main flooding vent. There is a set of wires in the hull which connect the motors with the acumulator pack. There is a holder for 3 servos in the water tight compartment (WTC). The linkages are sealed with rubber sleeves.

MOTOR CASE

Motor case could be retrieved completely from the hull together with wiring. The access is granted by the removable cover with O-ring rubber seal. The case's shape is corresponding to the shape of the hull at the place where it is to be installed (compatible with Revell type VII/C, VII/C 41 hulls).

 

ELECTRIC MOTORS WITH SHAFT AND CLUTCH

Assembly of the two electromotors with clutches and teflone inserts. The screws are counter-revolving. The shafts are made out of stainless steel and have a small hole for grease filling.

RUDDERS LINKAGES

The linkages for all the diving planes on the submarine are leading to the servos; the forward and aft diving planes are connected together trough a lever mechanizm located on the electromotor's case. Another linkage controls bot rudders at the same time.

ACCESSORIES

Spaghetti shrinkable insulation, sealing spaghetti insulation, rubber O-ring sealings and laser-made span (allows to tighen/lose screws on the electromotor case and pressure tank). Gold-plated connectors for electrical wiring.

SYSTEM JOG-4 FUNCTION ON REFILL CO2 8g

Czech Cylinders     Germany Cylinders

 

Etched deck for U-boot U-505 IXC or U-190  IXC/40


First test